What is the difference between a steam boiler and a ste

Steam boiler : An steam boiler consists of only the containing vessel and convection heating surfaces. It is used to convert water into steam at sub-critical pressures. Steam generator: An steam generator covers the whole unit encompassing water tubes, fi

qianxin@zozen.com > Get A Quote >

Steam Turbine-HP Differential Expansi

300MW steam power plant..Rated temperature and Pressure in inlet of Turbine is 540 deg C & 16 Mpa. Every time during warm startup (Steam temp allowable is >370 deg and pressure >5.88 Mpa, when casing temperature >150 deg), HP Diff expansion increases to m

qianxin@zozen.com > Get A Quote >

boiler operating pressure requirments - Boiler and Pressu

33 bars, 370C superheated steam, steam flow at 32 ton per hour. Unless you want to run your generator at some lower efficiency (use non-superheated steam) or lower rating (provide less steam pressure and less steam flow) your temporary boiler will have to

qianxin@zozen.com > Get A Quote >

Steam Calculators: Boiler Calculat

Steam, Boiler, and Blowdown Pressure are the same. Combustion Efficiency is the % of fuel energy that is directly added to the feedwater and not otherwise lost or used. Blowdown Rate is the % of incoming feedwater mass flow rate that leaves the boiler as

qianxin@zozen.com > Get A Quote >

Steam Power plant (Reheat) | Physics Foru

1. The problem statement, all variables and given/known data 2. Relevant equations Heat added, Qa (This I'm not sure how since the steam passed through a

qianxin@zozen.com > Get A Quote >

hot water boiler tap - agrilifeumbria.

Boiler problem - my hot water tap runs hot then cold? | Yahoo The boiler will be fitted with a low pressure or flow switch,if there isn't enough water in the boiler then you shouldn't get any hot water as the boiler just won't operate.

qianxin@zozen.com > Get A Quote >

Steam turbine exhaust enthalpy determination - Heat Transf

The steam turbine + generator is designed for 6 MW power generation. Thsi is an extraction-condensing type turbine. Inlet steam pressure 44 bar, inlet steam flow is about 25 tons/hour. After first stage, pressure is 15 bar and temperature is 370 Deg.C. Co

qianxin@zozen.com > Get A Quote >

Steam Generator vs. Steam Boiler | Powerhou

As water passes through the coil, the heat is transferred from the hot gases which causes the water to convert to steam. The generator design does not utilize a steam drum where the steam of a boiler has a disengagement area from the water in so the use o

qianxin@zozen.com > Get A Quote >

Thermodynamics 2 - Rankine Cycle.pptx | Steam Engine | He

16 174-175 (Sta. Maria) In a 35,000 kW turbo-generator that receives steam at 6.9 MPa and 370C, 11% of the throttle steam is actually extracted at 2MPa, 215C; with the remainder being reheated to 1.8 MPa and 315C; then 20% of the throttle steam is actuall

qianxin@zozen.com > Get A Quote >

APPLIED THERMODYNAMICS REVISION OF ISENTROPIC EFFICIEN

with a steam turbine and generator and the process steam is obtained in two ways as follows. x By exhausting the steam at the required pressure (typically 2 bar) to the process instead of to the condenser. A turbine designed to do this is called a BACK-PR

qianxin@zozen.com > Get A Quote >

Steam Tables Calculat

Calculate online thermodynamic and transport properties of water and steam, based on industrial (IAPWS-IF97) or scientific (IAPWS-95) formulation. Mollier diagrams included.

qianxin@zozen.com > Get A Quote >

Need more information?

Contact us for more details about our boilers, solutions and services.

Gas-fired(oil-fired) boilers
Coal-fired boilers
Biomass-fired boilers
Thermal fluid heaters
Hot water/oil
0.7-14 MW
14.1-21 MW
21.1-29 MW
29.1-75 MW
Steam
1-10 t/h
11-20 t/h
21-90 t/h
91-140 t/h

Chat Now

Latest Post

Need More?